periph_conf.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2014 Freie Universität Berlin
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#include "periph_cpu.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#define XTAL_HZ             (16000000U)         /* the board provides a 16 MHz XTAL */
 
#define CLOCK_CORECLOCK     (72000000U)         /* this board runs with 72MHz */
 
#define CLOCK_PCLK          (CLOCK_CORECLOCK)
#define TIMER_NUMOF         (1U)
static const uart_conf_t uart_config[] = {
    {
        .dev = UART0,
        .irq_prio_rx = 6,
        .pinsel_rx   = 0,
        .pinsel_tx   = 0,
        .pinsel_msk_rx = BIT4,
        .pinsel_msk_tx = BIT6,
    }
};
 
#define UART_NUMOF          (1)
static const spi_conf_t spi_config[] = {
    {
        .dev = SPI0,
        .pinsel_mosi = 3,
        .pinsel_miso = 3,
        .pinsel_clk  = 3,
        .pinsel_msk_mosi = (BIT16 | BIT17),
        .pinsel_msk_miso = (BIT14 | BIT15),
        .pinsel_msk_clk  = (BIT8  | BIT9),
    },
};
 
#define SPI_NUMOF           (1)
#ifdef __cplusplus
}
#endif