STM32 Nucleo-F072RB
Support for the STM32 Nucleo-F072RB. More...
Detailed Description
Support for the STM32 Nucleo-F072RB.
Overview
The Nucleo-F072RB is a board from ST's Nucleo family supporting a ARM Cortex-M0 STM32F072RB microcontroller with 16KiB of RAM and 128KiB of Flash.
You can find general information about the Nucleo64 boards on the STM32 Nucleo-64 page.
Hardware
Pinout
Pinout for the Nucleo-F072RB (from user manual UM1724, http://www.st.com/resource/en/user_manual/dm00105823.pdf, page 29)
MCU
| MCU | STM32F072RB |
|---|---|
| Family | ARM Cortex-M0 |
| Vendor | ST Microelectronics |
| RAM | 16KiB |
| Flash | 128KiB |
| Frequency | up to 48MHz |
| FPU | no |
| Timers | 12 (2x watchdog, 1 SysTick, 8x 16-bit, 1x 32-bit) |
| ADCs | 1x 12-bit (up to 16 channels) |
| UARTs | 4 |
| SPIs | 2 |
| I2Cs | 2 |
| CAN | 1 |
| USB | 1 |
| RTC | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F072RB | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (4 pins available) | ||
| UART | 3 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA09(TX) and USART3 on PC11(RX)/PC10(TX) | |
| PWM | 7 pins | ||
| ADC | 6 pins | ||
| I2C | no | ||
| SPI | yes (SPI1) | ||
| USB | no | ||
| Timer | 1 32 bit timers (TIM1) |
Flashing the Board
A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F072RB is nucleo-f072rb.
Files | |
| file | periph_conf.h |
| Peripheral MCU configuration for the nucleo-f072rb board. | |
