STM32 Nucleo-F207ZG
Support for the STM32 Nucleo-F207ZG. More...
Detailed Description
Support for the STM32 Nucleo-F207ZG.
Overview
The Nucleo-F207ZG is a board from ST's Nucleo family supporting a ARM Cortex-M3 STM32F207ZG microcontroller with 128KiB of SRAM and 1MiB of ROM Flash.
You can find general information about the Nucleo144 boards on the STM32 Nucleo-144 page.
Hardware
Pinout
Pinout for the Nucleo-F207ZG (from STM user manual, UM1974, http://www.st.com/resource/en/user_manual/dm00244518.pdf, page 32)
MCU
| MCU | STM32F207ZG |
|---|---|
| Family | ARM Cortex-M3 |
| Vendor | ST Microelectronics |
| RAM | 128KiB |
| Flash | 1MiB |
| Frequency | up to 120MHz |
| FPU | no |
| Timers | 17 (2x watchdog, 1 SysTick, 12x 16-bit, 2x 32-bit [TIM2]) |
| ADCs | 3x 12-bit (24 channels) |
| UARTs | 6 |
| SPIs | 3 |
| I2Cs | 3 |
| RTC | 1 |
| CAN | 2 |
| USB | 1 |
| Ethernet | 1 |
| Vcc | 1.8V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F207ZG | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (7 pins available in see PR #6192) | ||
| UART | 2 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX) and USART6 on PA12(RX)/PA11(TX) | |
| I2C | 1 I2C | ||
| SPI | 1 SPI | ||
| USB | no | ||
| Timer | 2 32 bit timers |
Flashing the Board
A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F207ZG is nucleo-f207zg.
Files | |
| file | periph_conf.h |
