STM32 Nucleo-F410RB
Support for the STM32 Nucleo-F410RB. More...
Detailed Description
Support for the STM32 Nucleo-F410RB.
Overview
The Nucleo-F410RB is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F410RB microcontroller with 32KiB of RAM and 128KiB of Flash.
You can find general information about the Nucleo64 boards on the STM32 Nucleo-64 page.
Hardware
Pinout
Pinout for the Nucleo-F410RB (from STM user manual UM1724, http://www.st.com/resource/en/user_manual/dm00105823.pdf, page 36)
MCU
| MCU | STM32F410RBT |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | ST Microelectronics |
| RAM | 32KiB |
| Flash | 128KiB |
| Frequency | up to 100MHz |
| FPU | yes |
| Timers | 9 (2x watchdog, 1x SysTick, 4x 16-bit, 1x 32-bit [TIM2] and 1 low power timer) |
| ADCs | 1x 12-bit (16 channels) |
| UARTs | 3 |
| SPIs | 3 |
| I2Cs | 3 |
| RTC | 1 |
| Vcc | 1.8V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F410RB | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (no pin configured) | ||
| UART | 2 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX) and USART1 on PA10(RX)/PA9(TX) | |
| I2C | 1 I2C | ||
| SPI | 1 SPI | ||
| USB | no | ||
| Timer | 2 32 bit timers |
Flashing the Board
A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F401RB is nucleo-f401rb.
Files | |
| file | periph_conf.h |
