board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2020 Inria
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#include "cpu.h"
#include "periph/gpio.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#define LED0_PIN            GPIO_PIN(PA, 23)                    
#define LED_PORT            PORT->Group[PA]                     
#define LED0_MASK           (1 << 23)                           
#define LED0_ON             (LED_PORT.OUTSET.reg = LED0_MASK)   
#define LED0_OFF            (LED_PORT.OUTCLR.reg = LED0_MASK)   
#define LED0_TOGGLE         (LED_PORT.OUTTGL.reg = LED0_MASK)   
#define LED0_NAME           "LED(Red)"                          
#define BUTTON_LATCH        GPIO_PIN(PB, 0)                     
#define BUTTON_CLK          GPIO_PIN(PB, 31)                    
#define BUTTON_OUT          GPIO_PIN(PB, 30)                    
#define BACKLIGHT_PIN          GPIO_PIN(PA, 1)                  
#define BACKLIGHT_PORT         PORT->Group[PA]                  
#define BACKLIGHT_MASK         (1 << 1)                         
#define BACKLIGHT_ON           (BACKLIGHT_PORT.OUTSET.reg = BACKLIGHT_MASK) 
#define BACKLIGHT_OFF          (BACKLIGHT_PORT.OUTCLR.reg = BACKLIGHT_MASK) 
#define ST77XX_PARAM_CNTRL      ST77XX_CNTRL_ST7735             
#define ST77XX_PARAM_SPI        SPI_DEV(1)                      
#define ST77XX_PARAM_CS         GPIO_PIN(PB, 7)                 
#define ST77XX_PARAM_DCX        GPIO_PIN(PB, 5)                 
#define ST77XX_PARAM_RST        GPIO_PIN(PA, 0)                 
#define ST77XX_PARAM_NUM_LINES  (160U)                          
#define ST77XX_PARAM_RGB_CHANNELS   (128U)                      
#define ST77XX_PARAM_RGB        (1)                             
#define ST77XX_PARAM_INVERTED   (0)                             
#define ST77XX_PARAM_ROTATION   ST77XX_ROTATION_90              
#define LCD_SCREEN_WIDTH        (ST77XX_PARAM_NUM_LINES)        
#define LCD_SCREEN_HEIGHT       (ST77XX_PARAM_RGB_CHANNELS)     
#define WS281X_PARAM_PIN        (GPIO_PIN(PA, 15))              
#define WS281X_PARAM_NUMOF      (5U)                            
#define SPEAKER_ENABLE_PIN      GPIO_PIN(PA, 27)                
#define SPEAKER_PIN             GPIO_PIN(PA, 2)                 
#define MTD_0 mtd_dev_get(0)                                    
#define XTIMER_WIDTH                (32)                        
#define XTIMER_HZ                   (1000000ul)                 
#ifdef __cplusplus
}
#endif