board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2019 Benjamin Valentin
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#ifdef __cplusplus
extern "C" {
#endif
 
#include "periph_cpu.h"
 
#define XTIMER_BACKOFF              (8)
#define XTIMER_OVERHEAD             (6)
#define LED0_PIN_NUM        13
#define LED0_PORT           GPIO_PORT_C 
#define LED0_PORT_NUM       PORT_C
#define LED0_IS_INVERTED    1
#define BTN0_PIN            GPIO_PIN(PORT_A, 0)
#define BTN0_MODE           GPIO_IN_PU
#define WEACT_4X1CX_NOR_PAGE_SIZE          (256)
#define WEACT_4X1CX_NOR_PAGES_PER_SECTOR   (16)
#define WEACT_4X1CX_NOR_FLAGS              (SPI_NOR_F_SECT_4K | SPI_NOR_F_SECT_32K)
#define WEACT_4X1CX_NOR_SPI_DEV            SPI_DEV(0)
#define WEACT_4X1CX_NOR_SPI_CLK            SPI_CLK_10MHZ
#define WEACT_4X1CX_NOR_SPI_CS             GPIO_PIN(PORT_A, 4)
#define WEACT_4X1CX_NOR_SPI_MODE           SPI_MODE_0
#define MTD_0 mtd_dev_get(0)
#ifdef __cplusplus
}
#endif
 
#include "stm32_leds.h"