board.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2021 Inria
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "cpu.h"
19 #include "periph_conf.h"
20 #include "periph_cpu.h"
21 
22 #ifdef __cplusplus
23 extern "C" {
24 #endif
25 
30 #define BACKLIGHT_PIN GPIO_PIN(PORT_K, 3)
31 #define BACKLIGHT_MASK (1 << 3)
34 #define BACKLIGHT_ON (GPIOK->BSRR = BACKLIGHT_MASK)
36 #define BACKLIGHT_OFF (GPIOK->BSRR = (BACKLIGHT_MASK << 16))
38 #define BACKLIGHT_TOGGLE (GPIOK->ODR ^= BACKLIGHT_MASK)
45 #define LCD_DISP_PIN GPIO_PIN(PORT_I, 12)
52 #define LCD_SCREEN_WIDTH 480
53 #define LCD_SCREEN_HEIGHT 272
60 #define LED0_PIN_NUM 1
61 #define LED0_PORT GPIO_PORT_I
62 #define LED0_PORT_NUM PORT_I
69 #define BTN0_PIN GPIO_PIN(PORT_I, 11)
70 #define BTN0_MODE GPIO_IN
77 #define FT5X06_PARAM_I2C_DEV I2C_DEV(1)
78 #define FT5X06_PARAM_INT_PIN GPIO_PIN(PORT_I, 13)
79 #define FT5X06_PARAM_XMAX LCD_SCREEN_WIDTH
80 #define FT5X06_PARAM_YMAX LCD_SCREEN_HEIGHT
81 #define FT5X06_PARAM_XYCONV FT5X06_SWAP_XY
82 #define FT5X06_PARAM_TYPE FT5X06_TYPE_FT5336
85 #ifdef __cplusplus
86 }
87 #endif
88 
89 #include "stm32_leds.h"
90 
periph_conf.h
Peripheral MCU configuration for the Zigduino board.
stm32_leds.h
Common LED macros.