Support for the STM32L0538-DISCO board. More...
Detailed Description
Support for the STM32L0538-DISCO board.
Introduction
The STM32L0538-DISCO discovery kit features an ultra low-power stm32l053c8t6 microcontroller with 64KB of FLASH and 8KB of RAM. The board also provides an on-board 2.04" E-paper display (not supported yet).
Pinout
MCU
| MCU | STM32L053C8 |
|---|---|
| Family | ARM Cortex-M0+ |
| Vendor | ST Microelectronics |
| RAM | 8KiB |
| Flash | 64KiB |
| Frequency | up to 32 MHz |
| Timers | 9 (2x watchdog, 1 SysTick, 5x 16-bit, 1x RTC) |
| ADCs | 1x 12 bit (up to 16 channels) |
| UARTs | 3 (two USARTs and one Low-Power UART) |
| I2Cs | 2 |
| SPIs | 4 |
| RTC | 1 |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Supported features
| Peripheral | Configuration |
|---|---|
| TIMs | TIM2 |
| UARTs | USART1 on PA10 (RX), PA9 (TX) |
| SPIs | SPI1 on PB5 (MOSI), PB4 (MISO), PB3 (SCLK); SPI2 on PB15 (MOSI), PB14 (MISO), PB13 (SCLK) |
Flashing the device
Flashing the board using OpenOCD
The board can be flashed using OpenOCD via the on-board ST-Link adapter. Then use the following command:
make BOARD=stm32l0538-disco -C examples/basic/hello-world flash
Flashing the Board Using ST-LINK Removable Media
On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:
- Note
- This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.
STDIO
STDIO is connected to pins PA9 (TX) and PA10 (RX) so an USB to UART adapter is required. Use the term target to open a terminal:
make BOARD=stm32l0538-disco -C examples/basic/hello-world term
If an external ST-Link adapter is used, RX and TX pins can be directly connected to it. In this case, STDIO is available on /dev/ttyACMx (Linux case).
Files | |
| file | board.h |
| Board specific definitions for the STM32L0538-DISCO evaluation board. | |
| file | gpio_params.h |
| Board specific configuration of direct mapped GPIOs. | |
| file | periph_conf.h |
| Peripheral MCU configuration for the STM32L0538-DISCO board. | |
