Support for the STM32 Nucleo-F303ZE. More...
Support for the STM32 Nucleo-F303ZE.
The Nucleo-F303ZE is a board from ST's Nucleo family supporting a ARM Cortex-M4 STM32F303ZE microcontroller with 64KiB of RAM and 512KiB of ROM.
You can find general information about the Nucleo144 boards on the STM32 Nucleo-144 page.

| MCU | STM32F303ZE |
|---|---|
| Family | ARM Cortex-M4F |
| Vendor | ST Microelectronics |
| RAM | 64KiB |
| Flash | 512KiB |
| Frequency | up to 72MHz |
| FPU | yes |
| Timers | 14 (10x 16-bit, 1x 32-bit [TIM2], 1x Systick, 2x watchdog) |
| ADCs | 4x 12-bit (40 channels) |
| UARTs | 5 |
| SPIs | 4 |
| I2Cs | 3 |
| RTC | 1 |
| CAN | 1 |
| USB | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F303ZE | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | one PWM | ||
| UART | three UART | ||
| I2C | two I2C | ||
| SPI | two SPI | ||
| USB | no | ||
| Timer | one 32 timer |
A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F303ZE is nucleo-f303ze.
Files | |
| file | periph_conf.h |