STM32 Nucleo-F746ZG

Support for the STM32 Nucleo-F746ZG. More...

Detailed Description

Support for the STM32 Nucleo-F746ZG.

Overview

The Nucleo-F746ZG is a board from ST's Nucleo family supporting ARM Cortex-M7 STM32F746ZG microcontroller with 320KiB of RAM and 1 MiB of Flash.

Pinout

Pinout for the Nucleo-F746ZG (from STM user manual, UM1974, http://www.st.com/resource/en/user_manual/dm00244518.pdf, page 32)

MCU

MCU	STM32F746ZG
Family	ARM Cortex-M7
Vendor	ST Microelectronics
RAM	320KiB
Flash	1MiB
Frequency	up to 216MHz
FPU	yes
Timers	18 (12x 16-bit, 2x 32, 1x RTC, 1x Systick, 2x Watchdog)
ADC	3x 12-bit (24 channels)
UARTs	4 (four USARTs/UARTs)
SPIs	6
CANs	2
RTC	1
I2Cs	4
Vcc	1.7V - 3.6V
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-f746zg PROGRAMMER=cpy2remed flash

Note

This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates can be found on this STM webpage.

Files
file	periph_conf.h
	Peripheral MCU configuration for the nucleo-f746zg board.