STM32 Nucleo-G071RB

Support for the STM32 Nucleo-G071RB. More...

Detailed Description

Support for the STM32 Nucleo-G071RB.

Overview

The Nucleo-G071RB is a board from ST's Nucleo family supporting a ARM Cortex-M0+ STM32G071RB microcontroller with 36KiB of RAM and 128KiB of Flash.

Pinout

Pinout for the Nucleo-G071RG (from STM user manual UM2324, https://www.st.com/resource/en/user_manual/um2324-stm32-nucleo64-boards-mb1360-stmicroelectronics.pdf, page 34)

MCU

MCU	STM32G071RB
Family	ARM Cortex-M0+
Vendor	ST Microelectronics
RAM	36KiB
Flash	128KiB
Frequency	up to 64 MHz
Timers	14 (2x watchdog, 1 SysTick, 10x 16-bit and 1 32-bit)
ADCs	1x 12 bit (up to 16 channels)
UARTs	5 (four USARTs and one Low-Power UART)
I2Cs	2
SPIs	2
RTC	1
Datasheet	Datasheet
Reference Manual	Reference Manual
Programming Manual	Programming Manual
Board Manual	Board Manual

Flashing the Board Using ST-LINK Removable Media

On-board ST-LINK programmer provides via composite USB device removable media. Copying the HEX file causes reprogramming of the board. This task could be performed manually; however, the cpy2remed (copy to removable media) PROGRAMMER script does this automatically. To program board in this manner, use the command:

make BOARD=nucleo-g071rb PROGRAMMER=cpy2remed flash

Note

This PROGRAMMER was tested using ST-LINK firmware 2.37.26. Firmware updates could be found on this STM webpage.

Files
file	periph_conf.h
	Peripheral MCU configuration for the nucleo-g071rb board.