board.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2019 Yegor Yefremov
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
29 #include <stdint.h>
30 
39 #if MODULE_ESP32_TTGO_T_BEAM_V1_0
40 #define BTN0_PIN GPIO38
41 #else
42 #define BTN0_PIN GPIO39
43 #endif
44 
51 #define BTN0_MODE GPIO_IN
52 
56 #define BUTTON0_PIN BTN0_PIN
62 #ifndef BTN0_INT_FLANK
63 #define BTN0_INT_FLANK GPIO_FALLING
64 #endif
65 
71 #ifndef MODULE_ESP32_TTGO_T_BEAM_V1_0
72 #define LED0_PIN GPIO14
73 #define LED0_ACTIVE (1)
74 #endif
83 #define SX127X_PARAM_SPI_NSS GPIO18
84 #define SX127X_PARAM_RESET GPIO23
85 #define SX127X_PARAM_DIO0 GPIO26
86 #define SX127X_PARAM_DIO1 GPIO_UNDEF /* Pin is not connected to the LoRa chip directly */
87 #define SX127X_PARAM_DIO2 GPIO_UNDEF /* Pin is not connected to the LoRa chip directly */
88 #define SX127X_PARAM_DIO3 GPIO_UNDEF
91 /* include common board definitions as last step */
92 #include "board_common.h"
93 
94 #ifdef __cplusplus
95 extern "C" {
96 #endif
97 
98 #ifdef __cplusplus
99 } /* end extern "C" */
100 #endif
101