board.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2018 HAW Hamburg
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
19 #ifdef __cplusplus
20 extern "C" {
21 #endif
22 
27 #define XTIMER_WIDTH (16)
28 #define XTIMER_BACKOFF (50)
29 #define XTIMER_ISR_BACKOFF (40)
36 #define LED0_PIN_NUM 1
37 #define LED0_PORT GPIO_PORT_A
38 #define LED0_PORT_NUM PORT_A
39 #define LED0_IS_INVERTED 1
40 
41 #define EN3V3_PORT GPIOA
42 #define EN3V3_PIN GPIO_PIN(PORT_A, 11)
43 #define EN3V3_MASK (1 << 11)
44 
45 #define EN3V3_ON (EN3V3_PORT->BSRR = EN3V3_MASK)
46 #define EN3V3_OFF (EN3V3_PORT->BSRR = (EN3V3_MASK << 16))
47 #define EN3V3_TOGGLE (EN3V3_PORT->ODR ^= EN3V3_MASK)
56 #define SX127X_PARAM_SPI_NSS GPIO_PIN(PORT_B, 0)
57 #define SX127X_PARAM_RESET GPIO_PIN(PORT_A, 4)
58 #define SX127X_PARAM_DIO0 GPIO_PIN(PORT_B, 1)
59 #define SX127X_PARAM_DIO1 GPIO_PIN(PORT_B, 10)
60 #define SX127X_PARAM_DIO2 GPIO_PIN(PORT_B, 11)
61 #define SX127X_PARAM_DIO3 GPIO_PIN(PORT_B, 7)
64 #ifdef __cplusplus
65 }
66 #endif
67 
68 #include "stm32_leds.h"
69 
stm32_leds.h
Common LED macros.