board.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2025 Mesotic SAS
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
19 #include "cpu.h"
20 #include "periph_conf.h"
21 #include "periph_cpu.h"
22 #include "periph/gpio.h"
23 
24 #ifdef __cplusplus
25 extern "C" {
26 #endif
27 
32 #define CONFIG_ZTIMER_USEC_WIDTH (16)
39 #define LED0_PIN GPIO_PIN(PC, 23)
40 
41 #define LED0_ON (PIOC->PIO_CODR = PIO_PC23)
42 #define LED0_OFF (PIOC->PIO_SODR = PIO_PC23)
43 #define LED0_TOGGLE ((PIOC->PIO_ODSR & PIO_PC23) ? LED0_ON : LED0_OFF)
50 #define BTN0_PIN GPIO_PIN(PA, 2)
51 #define BTN0_MODE GPIO_IN_PU
54 #ifdef __cplusplus
55 }
56 #endif
57 
periph_conf.h
Peripheral MCU configuration for the Zigduino board.
gpio.h
Low-level GPIO peripheral driver interface definitions.