board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2014 Freie Universität Berlin
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#include <stdint.h>
 
#include "cpu.h"
#include "periph_conf.h"
 
#ifdef __cplusplus
 extern "C" {
#endif
 
#define XTIMER_WIDTH        (16)
 
#define LED0_PIN_NUM        9
#define LED0_PORT           GPIO_PORT_A 
#define LED0_PORT_NUM       PORT_A
 
#define LED1_PIN_NUM        10
#define LED1_PORT           GPIO_PORT_A 
#define LED1_PORT_NUM       PORT_A
 
#define LED2_PIN_NUM        8
#define LED2_PORT           GPIO_PORT_A 
#define LED2_PORT_NUM       PORT_A
 
#define LED3_PIN_NUM        13
#define LED3_PORT           GPIO_PORT_A 
#define LED3_PORT_NUM       PORT_A
#define BUTTON1             GPIO_PIN(PORT_B,2)
#define CC3000_SPI          SPI_DEV(0)
#define CC3000_CS           GPIO_PIN(PORT_B,12)
#define CC3000_EN           GPIO_PIN(PORT_B,8)
#define CC3000_INT          GPIO_PIN(PORT_B,11)
#define EXTFLASH_SPI        SPI_DEV(0)
#define EXTFLASH            GPIO_PIN(PORT_B,9)
#ifdef __cplusplus
} /* end extern "C" */
#endif
 
#include "stm32_leds.h"