board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2013-2014 INRIA
 * SPDX-FileCopyrightText: 2015 Freie Universität Berlin
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#include "cpu.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
#ifndef __MSP430F1611__
#define __MSP430F1611__
#endif
 
#ifndef STDIO_UART_BAUDRATE
#define STDIO_UART_BAUDRATE         (9600)
#endif
#define CONFIG_ZTIMER_USEC_WIDTH        16      
#define CONFIG_ZTIMER_USEC_BASE_FREQ    MHZ(1)
#define CONFIG_ZTIMER_PERIPH_TIMER_FORCE_CONVERSION     1
#define XTIMER_WIDTH                (16)
#define XTIMER_BACKOFF              (40)
#define LED0_PIN                    GPIO_PIN(4, 0)
#define LED1_PIN                    GPIO_PIN(4, 1)
#define LED2_PIN                    GPIO_PIN(4, 2)
 
#define LED_OUT_REG                 P5OUT
#define LED0_MASK                   (0x10)
#define LED1_MASK                   (0x20)
#define LED2_MASK                   (0x40)
 
#define LED0_ON                     (LED_OUT_REG &=~LED0_MASK)
#define LED0_OFF                    (LED_OUT_REG |= LED0_MASK)
#define LED0_TOGGLE                 (LED_OUT_REG ^= LED0_MASK)
 
#define LED1_ON                     (LED_OUT_REG &=~LED1_MASK)
#define LED1_OFF                    (LED_OUT_REG |= LED1_MASK)
#define LED1_TOGGLE                 (LED_OUT_REG ^= LED1_MASK)
 
#define LED2_ON                     (LED_OUT_REG &=~LED2_MASK)
#define LED2_OFF                    (LED_OUT_REG |= LED2_MASK)
#define LED2_TOGGLE                 (LED_OUT_REG ^= LED2_MASK)
#define CC2420_PARAM_SPI_CLK        (SPI_CLK_1MHZ)
#define CC2420_PARAM_CS             GPIO_PIN(P4, 2)
#define CC2420_PARAM_FIFO           GPIO_PIN(P1, 3)
#define CC2420_PARAM_FIFOP          GPIO_PIN(P1, 0)
#define CC2420_PARAM_CCA            GPIO_PIN(P1, 4)
#define CC2420_PARAM_SFD            GPIO_PIN(P4, 1)
#define CC2420_PARAM_VREFEN         GPIO_PIN(P4, 5)
#define CC2420_PARAM_RESET          GPIO_PIN(P4, 6)
#ifdef __cplusplus
}
#endif