STM32 Nucleo-F103RB
Support for the STM32 Nucleo-F103RB. More...
Detailed Description
Support for the STM32 Nucleo-F103RB.
Overview
The Nucleo-F103RB is a board from ST's Nucleo family supporting a ARM Cortex-M3 STM32F103RB microcontroller with 20KiB of RAM and 128KiB of Flash.
You can find general information about the Nucleo64 boards on the STM32 Nucleo-64 page.
Hardware
Pinout
Pinout for the Nucleo-F103RB (from user manual UM1724, http://www.st.com/resource/en/user_manual/dm00105823.pdf, page 30)
MCU
| MCU | STM32F103RB |
|---|---|
| Family | ARM Cortex-M3 |
| Vendor | ST Microelectronics |
| RAM | 20KiB |
| Flash | 128KiB |
| Frequency | up to 72MHz |
| FPU | no |
| Timers | 7 (2x watchdog, 1 SysTick, 4x 16-bit) |
| ADCs | 1x 12-bit (16 channels) |
| UARTs | 3 |
| SPIs | 2 |
| I2Cs | 2 |
| RTC | 1 |
| USB | 1 |
| CAN | 1 |
| Vcc | 2.0V - 3.6V |
| Datasheet | Datasheet |
| Reference Manual | Reference Manual |
| Programming Manual | Programming Manual |
| Board Manual | Board Manual |
Implementation Status
| Device | ID | Supported | Comments |
|---|---|---|---|
| MCU | STM32F103RB | partly | Energy saving modes not fully utilized |
| Low-level driver | GPIO | yes | |
| PWM | yes (4 pins available) | ||
| UART | 2 UARTs | USART2 via STLink/USB or D0(RX)/D1(TX), USART1 on PA10(RX)/PA09(TX) and USART3 on PB11(RX)/PB10(TX) | |
| ADC | yes | Pins A0 - A5 | |
| I2C | yes (I2C1 and I2C2) | ||
| SPI | yes (SPI1 and SPI2) | ||
| USB | no | ||
| Timer | 2 16 bit timers (TIM2 and TIM3) |
Flashing the Board
A detailed description about the flashing process can be found on the guides page. The board name for the Nucleo-F103RB is nucleo-f103rb.
Files | |
| file | periph_conf.h |
| Peripheral MCU configuration for the nucleo-f103rb board. | |
