board.h

Go to the documentation of this file.

/*
 * SPDX-FileCopyrightText: 2021 Inria
 * SPDX-License-Identifier: LGPL-2.1-only
 */
 
#pragma once
 
#include "kernel_defines.h"
#if IS_USED(MODULE_SX126X_STM32WL)
#include "sx126x.h"
#endif
 
#ifdef __cplusplus
extern "C" {
#endif
 
#define SX126X_PARAM_SPI                    (SPI_DEV(0))
#define SX126X_PARAM_TX_PA_MODE             SX126X_RF_MODE_TX_HPA
#if IS_USED(MODULE_SX126X_STM32WL)
extern void lora_e5_dev_sx126x_set_rf_mode(sx126x_t *dev, sx126x_rf_mode_t rf_mode);
#define SX126X_PARAM_SET_RF_MODE_CB         lora_e5_dev_sx126x_set_rf_mode
#define SX126X_PARAM_TYPE                   SX126X_TYPE_STM32WL
#endif
#define LED0_PORT           GPIO_PORT_B 
#define LED0_PORT_NUM       PORT_B
#define LED0_PIN_NUM        5
#define BTN0_PIN            GPIO_PIN(PORT_B, 13)
#define BTN0_MODE           GPIO_IN_PU
#define BTN1_PIN            GPIO_PIN(PORT_A, 0)
#define BTN1_MODE           GPIO_IN_PU
#define FE_CTRL1            GPIO_PIN(PORT_A, 4)
#define FE_CTRL2            GPIO_PIN(PORT_A, 5)
#ifndef CONFIG_LORA_E5_DEV_ENABLE_3P3V
#define CONFIG_LORA_E5_DEV_ENABLE_3P3V      1
#endif
#ifndef CONFIG_LORA_E5_DEV_ENABLE_5V
#define CONFIG_LORA_E5_DEV_ENABLE_5V        1
#endif
#define LORA_E5_DEV_3P3V_ENABLE_PIN         GPIO_PIN(PORT_A, 9)
#define LORA_E5_DEV_5V_ENABLE_PIN           GPIO_PIN(PORT_B, 10)
 
#ifdef __cplusplus
}
#endif
 
#include "stm32_leds.h"