gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2019 Robert Olsson <roolss@kth.se>
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "board.h"
19 #include "saul/periph.h"
20 
21 #ifdef __cplusplus
22 extern "C" {
23 #endif
24 
28 static const saul_gpio_params_t saul_gpio_params[] =
29 {
30  {
31  .name = "BTN0 (S2 BUTTON)",
32  .pin = BTN0_PIN,
33  .mode = BTN0_MODE,
34  .flags = SAUL_GPIO_INVERTED,
35  },
36  {
37  .name = "LED0 (Red)",
38  .pin = LED0_PIN,
39  .mode = LED0_MODE,
40  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
41  },
42  {
43  .name = "LED1 (Yellow)",
44  .pin = LED1_PIN,
45  .mode = LED1_MODE,
46  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
47  },
48 };
49 
50 #ifdef __cplusplus
51 }
52 #endif
53 
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
GPIO configuration.
Definition: gpio_params.h:28
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:43
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.