ITG320X device initialization parameters. More...

Detailed Description

ITG320X device initialization parameters.

Definition at line 147 of file itg320x.h.

#include <itg320x.h>

Data Fields
i2c_t	dev
	I2C device (default I2C_DEV(0))

uint8_t	addr
	I2C slave address (default ITG320X_I2C_ADDRESS_1)

uint8_t	isr_div
	Internal sample rate divider ISR_DIV (default 99) ODR = ISR / (ISR_DIV + 1) where internal sample rate is 1 kHz or 8 kHz dependent on the low pass filter bandwidth lpf_bw.

itg320x_lpf_bw_t	lpf_bw
	Low pass filter bandwidth (default ITG320X_LPF_BW_5, ISR 1 kHz)

itg320x_clk_sel_t	clk_sel
	Clock source selection (default ITG320X_CLK_PLL_X_GYRO)

gpio_t	int_pin
	DRDY interrupt pin: GPIO_UNDEF if not used.

itg320x_int_level_t	int_level
	Logic level for INT output pin (default ITG320X_INT_LOW)

itg320x_int_drive_t	int_drive
	Drive type for INT output pin (default ITG320X_INT_PUSH_PULL.

The documentation for this struct was generated from the following file:

Data Fields