periph_conf.h File Reference

Peripheral configuration for the nRF52840-Dongle. More...

Detailed Description

Peripheral configuration for the nRF52840-Dongle.

Author

Christian Amsüss chrys.nosp@m.n@fs.nosp@m.fe.or.nosp@m.g

Hauke Petersen hauke.nosp@m..pet.nosp@m.ersen.nosp@m.@fu-.nosp@m.berli.nosp@m.n.de

Definition in file periph_conf.h.

#include "periph_cpu.h"
#include "cfg_clock_32_1.h"
#include "cfg_rtt_default.h"
#include "cfg_timer_default.h"

Include dependency graph for periph_conf.h:

Go to the source code of this file.

UART configuration
This board does not have explicit UART pins. These are set as UART 0 to provide an easy serial debug port when not using (or debugging) USB.
#define	UART_0_ISR   (isr_uart0)
#define	UART_NUMOF   ARRAY_SIZE(uart_config)
static const uart_conf_t	uart_config []

PWM configuration
For the nRF52840-Dongle board, the PWM0 module is set to drive the LEDs LD1 and the channels LD2 red, green and blue in the four channels of PWM_DEV(0); other PWM outputs are not configured.
#define	PWM_NUMOF   ARRAY_SIZE(pwm_config)
static const pwm_conf_t	pwm_config []

SPI configuration
#define	SPI_NUMOF   ARRAY_SIZE(spi_config)
static const spi_conf_t	spi_config []

I2C configuration
#define	I2C_NUMOF   ARRAY_SIZE(i2c_config)
static const i2c_conf_t	i2c_config []

Variable Documentation

i2c_config

const i2c_conf_t i2c_config[]

static

Initial value:

= {
    {
        .dev = NRF_TWIM1,
        .scl = GPIO_PIN(0, 29),
        .sda = GPIO_PIN(0, 31),
        .speed = I2C_SPEED_NORMAL
    }
}

Definition at line 104 of file periph_conf.h.

pwm_config

const pwm_conf_t pwm_config[]

static

Initial value:

= {
    {
        NRF_PWM0,
        {
            GPIO_PIN(0, 6),
            GPIO_PIN(0, 8),
            GPIO_PIN(1, 9),
            GPIO_PIN(0, 12),
        },
    },
}

Definition at line 70 of file periph_conf.h.

spi_config

const spi_conf_t spi_config[]

static

Initial value:

= {
    {
        .dev  = NRF_SPIM0,
        .sclk = GPIO_PIN(0, 20),
        .mosi = GPIO_PIN(0, 22),
        .miso = GPIO_PIN(0, 24),
    }
}

Definition at line 88 of file periph_conf.h.

uart_config

const uart_conf_t uart_config[]

static

Initial value:

= {
    {
        .dev        = NRF_UARTE0,
        .rx_pin     = GPIO_PIN(0, 13),
        .tx_pin     = GPIO_PIN(0, 15),
 
 
 
 
        .irqn       = UARTE0_UART0_IRQn,
    },
}

Definition at line 43 of file periph_conf.h.