at86rf215.h

Go to the documentation of this file.

/*
 * Copyright (C) 2019 2019 ML!PA Consulting GmbH
 *
 * This file is subject to the terms and conditions of the GNU Lesser General
 * Public License v2.1. See the file LICENSE in the top level directory for more
 * details.
 */
 
#pragma once
 
#include <stdint.h>
#include <stdbool.h>
 
#include "board.h"
#include "periph/spi.h"
#include "periph/gpio.h"
#include "net/netdev.h"
#include "net/netdev/ieee802154.h"
#include "net/gnrc/nettype.h"
#include "xtimer.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
typedef struct at86rf215_RF_regs at86rf215_RF_regs_t;
 
typedef struct at86rf215_BBC_regs at86rf215_BBC_regs_t;
 
typedef void (*at86rf215_batmon_cb_t)(void *arg);
 
enum {
    AT86RF215_FCHIP_100,
    AT86RF215_FCHIP_200,
    AT86RF215_FCHIP_1000,
    AT86RF215_FCHIP_2000,
};
 
#define AT86RF215_MAX_PKT_LENGTH        (2047)
 
#ifdef DOXYGEN
#define CONFIG_AT86RF215_USE_CLOCK_OUTPUT
#endif
 
#if defined(DOXYGEN) && !defined(CONFIG_AT86RF215_TRIM_VAL)
#define CONFIG_AT86RF215_TRIM_VAL              (0)
#endif
 
#ifndef CONFIG_AT86RF215_DEFAULT_CHANNEL
#define CONFIG_AT86RF215_DEFAULT_CHANNEL        (CONFIG_IEEE802154_DEFAULT_CHANNEL)
#endif
 
#ifndef CONFIG_AT86RF215_DEFAULT_SUBGHZ_CHANNEL
#define CONFIG_AT86RF215_DEFAULT_SUBGHZ_CHANNEL (CONFIG_IEEE802154_DEFAULT_SUBGHZ_CHANNEL)
#endif
#ifndef CONFIG_AT86RF215_RPC_EN
#define CONFIG_AT86RF215_RPC_EN                 (0)
#endif
#ifndef CONFIG_AT86RF215_BATMON_THRESHOLD
#define CONFIG_AT86RF215_BATMON_THRESHOLD       (1800)
#endif
#if IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_LEGACY_OQPSK)
#define CONFIG_AT86RF215_DEFAULT_PHY_MODE   (IEEE802154_PHY_OQPSK)
#elif IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OQPSK)
#define CONFIG_AT86RF215_DEFAULT_PHY_MODE   (IEEE802154_PHY_MR_OQPSK)
#elif IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OFDM)
#define CONFIG_AT86RF215_DEFAULT_PHY_MODE   (IEEE802154_PHY_MR_OFDM)
#endif
 
#ifndef CONFIG_AT86RF215_DEFAULT_PHY_MODE
#define CONFIG_AT86RF215_DEFAULT_PHY_MODE   (IEEE802154_PHY_OQPSK)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_OQPSK_RATE
#define CONFIG_AT86RF215_DEFAULT_OQPSK_RATE     (0)
#endif
#if IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS_100)
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS (AT86RF215_FCHIP_100)
#elif IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS_200)
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS (AT86RF215_FCHIP_200)
#elif IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS_1000)
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS (AT86RF215_FCHIP_1000)
#elif IS_ACTIVE(CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS_2000)
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS (AT86RF215_FCHIP_2000)
#endif
 
#ifndef CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_CHIPS (AT86RF215_FCHIP_1000)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_OQPSK_RATE
#define CONFIG_AT86RF215_DEFAULT_MR_OQPSK_RATE  (2)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_OFDM_OPT
#define CONFIG_AT86RF215_DEFAULT_MR_OFDM_OPT    (2)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_OFDM_MCS
#define CONFIG_AT86RF215_DEFAULT_MR_OFDM_MCS    (2)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_FSK_SRATE
#define CONFIG_AT86RF215_DEFAULT_MR_FSK_SRATE   FSK_SRATE_200K
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_FSK_MOD_IDX
#define CONFIG_AT86RF215_DEFAULT_MR_FSK_MOD_IDX (64)
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_FSK_MORD
#define CONFIG_AT86RF215_DEFAULT_MR_FSK_MORD    FSK_MORD_4SFK
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_MR_FSK_FEC
#define CONFIG_AT86RF215_DEFAULT_MR_FSK_FEC     IEEE802154_FEC_NONE
#endif
#ifndef CONFIG_AT86RF215_DEFAULT_TXPOWER
#define CONFIG_AT86RF215_DEFAULT_TXPOWER       (CONFIG_IEEE802154_DEFAULT_TXPOWER)
#endif
 
typedef enum {
    AT86RF215_STATE_OFF,        
    AT86RF215_STATE_IDLE,       
    AT86RF215_STATE_RX_SEND_ACK,
    AT86RF215_STATE_TX,         
    AT86RF215_STATE_TX_WAIT_ACK,
    AT86RF215_STATE_SLEEP       
} at86rf215_state_t;
enum {
    AT86RF215_MODE_LEGACY_OQPSK,
    AT86RF215_MODE_MR_OQPSK,
    AT86RF215_MODE_MR_OFDM,
    AT86RF215_MODE_MR_FSK
};
 
typedef enum {
    AT86RF215_CLKO_2mA = 0 << 3,    
    AT86RF215_CLKO_4mA = 1 << 3,    
    AT86RF215_CLKO_6mA = 2 << 3,    
    AT86RF215_CLKO_8mA = 3 << 3,    
} at86rf215_clko_cur_t;
typedef enum {
    AT86RF215_CLKO_OFF = 0,         
    AT86RF215_CLKO_26_MHz,          
    AT86RF215_CLKO_32_MHz,          
    AT86RF215_CLKO_16_MHz,          
    AT86RF215_CLKO_8_MHz,           
    AT86RF215_CLKO_4_MHz,           
    AT86RF215_CLKO_2_MHz,           
    AT86RF215_CLKO_1_MHz,           
} at86rf215_clko_freq_t;
#define AT86RF215_OPT_CSMA           (0x0010)       
#define AT86RF215_OPT_PROMISCUOUS    (0x0020)       
#define AT86RF215_OPT_PRELOADING     (0x0040)       
#define AT86RF215_OPT_AUTOACK        (0x0080)       
#define AT86RF215_OPT_ACK_REQUESTED  (0x0100)       
#define AT86RF215_OPT_AGCH           (0x0200)       
#define AT86RF215_OPT_TX_PENDING     (0x0400)       
#define AT86RF215_OPT_CCA_PENDING    (0x0800)       
#define AT86RF215_OPT_RPC            (0x1000)       
#define AT86RF215_OPT_CCATX          (0x2000)       
#define AT86RF215_TIMEOUT_ACK        (0x0001)       
#define AT86RF215_TIMEOUT_CSMA       (0x0002)       
typedef struct at86rf215_params {
    spi_t spi;              
    spi_clk_t spi_clk;      
    spi_cs_t cs_pin;        
    gpio_t int_pin;         
    gpio_t reset_pin;       
} at86rf215_params_t;
 
typedef struct at86rf215 {
    netdev_ieee802154_t netdev;             
    /* device specific fields */
    at86rf215_params_t params;              
    struct at86rf215 *sibling;              
    const at86rf215_RF_regs_t  *RF;         
    const at86rf215_BBC_regs_t *BBC;        
    xtimer_t timer;                         
    uint32_t ack_timeout_usec;              
    uint32_t csma_backoff_period;           
    uint16_t flags;                         
    uint16_t num_chans;                     
    uint16_t tx_frame_len;                  
    uint8_t timeout;                        
    uint8_t state;                          
    uint8_t retries_max;                    
    uint8_t retries;                        
    uint8_t csma_retries_max;               
    uint8_t csma_retries;                   
#ifdef MODULE_NETDEV_IEEE802154_MR_FSK
    uint8_t fsk_pl;                         
#endif
    uint8_t csma_minbe;                     
    uint8_t csma_maxbe;                     
    int8_t  csma_ed;                        
} at86rf215_t;
 
void at86rf215_setup(at86rf215_t *dev_09, at86rf215_t *dev_24, const at86rf215_params_t *params, uint8_t index);
 
void at86rf215_reset_and_cfg(at86rf215_t *dev);
 
void at86rf215_reset(at86rf215_t *dev);
 
uint16_t at86rf215_get_addr_short(const at86rf215_t *dev, uint8_t filter);
 
void at86rf215_set_addr_short(at86rf215_t *dev, uint8_t filter, uint16_t addr);
 
bool at86rf215_get_framefilter_enabled(at86rf215_t *dev, uint8_t filter);
 
 void at86rf215_disable_framefilter(at86rf215_t *dev, uint8_t filter);
 
void at86rf215_enable_framefilter(at86rf215_t *dev, uint8_t filter);
 
uint64_t at86rf215_get_addr_long(const at86rf215_t *dev);
 
void at86rf215_set_addr_long(at86rf215_t *dev, uint64_t addr);
 
uint8_t at86rf215_get_chan(const at86rf215_t *dev);
 
void at86rf215_set_chan(at86rf215_t *dev, uint16_t chan);
 
uint16_t at86rf215_get_pan(const at86rf215_t *dev, uint8_t filter);
 
void at86rf215_set_pan(at86rf215_t *dev, uint8_t filter, uint16_t pan);
 
int16_t at86rf215_get_txpower(const at86rf215_t *dev);
 
void at86rf215_set_txpower(const at86rf215_t *dev, int16_t txpower);
 
int8_t at86rf215_get_cca_threshold(const at86rf215_t *dev);
 
void at86rf215_set_cca_threshold(at86rf215_t *dev, int8_t value);
 
int8_t at86rf215_get_ed_level(at86rf215_t *dev);
 
void at86rf215_set_option(at86rf215_t *dev, uint16_t option, bool state);
 
void at86rf215_set_trim(at86rf215_t *dev, uint8_t trim);
 
void at86rf215_set_clock_output(at86rf215_t *dev,
                                at86rf215_clko_cur_t cur, at86rf215_clko_freq_t freq);
 
ssize_t at86rf215_send(at86rf215_t *dev, const void *data, size_t len);
 
int at86rf215_tx_prepare(at86rf215_t *dev);
 
size_t at86rf215_tx_load(at86rf215_t *dev, const uint8_t *data,
                         size_t len, size_t offset);
 
int at86rf215_tx_exec(at86rf215_t *dev);
 
void at86rf215_tx_abort(at86rf215_t *dev);
 
void at86rf215_tx_done(at86rf215_t *dev);
 
bool at86rf215_cca(at86rf215_t *dev);
 
int at86rf215_enable_batmon(at86rf215_t *dev, unsigned voltage);
 
void at86rf215_disable_batmon(at86rf215_t *dev);
 
#ifdef __cplusplus
}
#endif