gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2020 Freie Universität Berlin
3  * SPDX-FileCopyrightText: 2023 HAW Hamburg
4  * SPDX-License-Identifier: LGPL-2.1-only
5  */
6 
7 #pragma once
8 
20 #include "board.h"
21 #include "saul/periph.h"
22 
23 #ifdef __cplusplus
24 extern "C" {
25 #endif
26 
30 static const saul_gpio_params_t saul_gpio_params[] =
31 {
32  {
33  .name = "LED Red (D13)",
34  .pin = LED0_PIN,
35  .mode = GPIO_OUT,
36  .flags = (SAUL_GPIO_INIT_CLEAR),
37  },
38  {
39  .name = "LED Blue (Conn)",
40  .pin = LED1_PIN,
41  .mode = GPIO_OUT,
42  .flags = (SAUL_GPIO_INIT_CLEAR),
43  },
44  {
45  .name = "UserSw",
46  .pin = BTN0_PIN,
47  .mode = BTN0_MODE,
48  .flags = SAUL_GPIO_INVERTED,
49  },
50 };
51 
52 #ifdef __cplusplus
53 }
54 #endif
55 
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition: gpio_params.h:30
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:164
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:43
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.