gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2024 TU Dresden
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
19 #include "board.h"
20 #include "saul/periph.h"
21 
22 #ifdef __cplusplus
23 extern "C" {
24 #endif
25 
29 static const saul_gpio_params_t saul_gpio_params[] =
30 {
31  {
32  .name = "LED Red (USR/D11)",
33  .pin = LED0_PIN,
34  .mode = GPIO_OUT,
35  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
36  },
37  {
38  .name = "LED Green (USR/D13)",
39  .pin = LED1_PIN,
40  .mode = GPIO_OUT,
41  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
42  },
43  {
44  .name = "LED Blue (USR/D12)",
45  .pin = LED2_PIN,
46  .mode = GPIO_OUT,
47  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
48  },
49 };
50 
51 #ifdef __cplusplus
52 }
53 #endif
54 
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition: board.h:32
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:164
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition: gpio_params.h:29
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:43
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.