USBUS compile time configurations

Detailed Description

Macros
#define	USBUS_STACKSIZE   (THREAD_STACKSIZE_DEFAULT)
	USBUS thread stack size.
#define	USBUS_PRIO   (THREAD_PRIORITY_MAIN - 6)
	USBUS thread priority.
#define	CONFIG_USBUS_AUTO_ATTACH   1
	USBUS auto attach setting. More...
#define	CONFIG_USBUS_MSC_AUTO_MTD   1
	USBUS MSC auto MTD setting. More...
#define	CONFIG_USBUS_EP0_SIZE   64
	USBUS endpoint 0 buffer size. More...

Macro Definition Documentation

CONFIG_USBUS_AUTO_ATTACH

#define CONFIG_USBUS_AUTO_ATTACH   1

USBUS auto attach setting.

When set to 1, the USBUS thread will automatically enable the USB pull-up resistor after initializing the thread. This will signal to the host that the USB peripheral is ready for use.

Definition at line 72 of file usbus.h.

CONFIG_USBUS_EP0_SIZE

#define CONFIG_USBUS_EP0_SIZE   64

USBUS endpoint 0 buffer size.

This configures the buffer size of the control endpoint. Unless you transfer large amount of data often over the control endpoint, a minimal size should be sufficient

Definition at line 104 of file usbus.h.

CONFIG_USBUS_MSC_AUTO_MTD

#define CONFIG_USBUS_MSC_AUTO_MTD   1

USBUS MSC auto MTD setting.

When set to 1, the USBUS MSC module will automatically create a LUN for each MTD device defined in board.h.

Definition at line 83 of file usbus.h.