Board specific definitions for the iotlab-m3 board. More...

Detailed Description

Board specific definitions for the iotlab-m3 board.

Author: Alaeddine Weslati alaed.nosp@m.dine.nosp@m..wesl.nosp@m.ati@.nosp@m.inria.nosp@m..fr; Thomas Eichinger thoma.nosp@m.s.ei.nosp@m.ching.nosp@m.er@f.nosp@m.u-ber.nosp@m.lin..nosp@m.de; Oliver Hahm olive.nosp@m.r.ha.nosp@m.hm@in.nosp@m.ria..nosp@m.fr; Hauke Petersen hauke.nosp@m..pet.nosp@m.ersen.nosp@m.@fu-.nosp@m.berli.nosp@m.n.de

#include <stdint.h>
#include "cpu.h"
#include "periph_conf.h"
#include "periph_conf_common.h"
#include "stm32_leds.h"

Include dependency graph for board_common.h:

Set the default baudrate to 500K for this board
#define	STDIO_UART_BAUDRATE (500000U)

Xtimer configuration
Tell the xtimer that we use a 16-bit peripheral timer
#define	XTIMER_WIDTH (16U)

ztimer configuration
#define	CONFIG_ZTIMER_USEC_TYPE ZTIMER_TYPE_PERIPH_TIMER

#define	CONFIG_ZTIMER_USEC_DEV TIMER_DEV(0)

#define	CONFIG_ZTIMER_USEC_MIN (2)

Define the interface to the AT86RF231 radio
{spi bus, spi speed, cs pin, int pin, reset pin, sleep pin}
#define	AT86RF2XX_PARAM_CS GPIO_PIN(PORT_A, 4)

#define	AT86RF2XX_PARAM_INT GPIO_PIN(PORT_C, 4)

#define	AT86RF2XX_PARAM_SLEEP GPIO_PIN(PORT_A, 2)

#define	AT86RF2XX_PARAM_RESET GPIO_PIN(PORT_C, 1)

LED pin definitions and handlers
#define	LED0_PIN_NUM 2

#define	LED0_PORT GPIO_PORT_D
	GPIO port of LED 0.

#define	LED0_PORT_NUM PORT_D

#define	LED1_PIN_NUM 5

#define	LED1_PORT GPIO_PORT_B
	GPIO port of LED 1.

#define	LED1_PORT_NUM PORT_B

#define	LED2_PIN_NUM 10

#define	LED2_PORT GPIO_PORT_C
	GPIO port of LED 2.

#define	LED2_PORT_NUM PORT_C

Set the default baudrate to 500K for this board