Shared files and configuration for the IoTlab boards. More...

Detailed Description

Shared files and configuration for the IoTlab boards.

Files
file	board_common.h
	Board specific definitions for the iotlab-m3 board.

file	gpio_params.h
	Board specific configuration of direct mapped GPIOs.

file	periph_conf_common.h
	Peripheral MCU configuration for the iotlab-m3 board.

Set the default baudrate to 500K for this board
#define	STDIO_UART_BAUDRATE (500000U)

Xtimer configuration
Tell the xtimer that we use a 16-bit peripheral timer
#define	XTIMER_WIDTH (16U)

ztimer configuration
#define	CONFIG_ZTIMER_USEC_TYPE ZTIMER_TYPE_PERIPH_TIMER

#define	CONFIG_ZTIMER_USEC_DEV TIMER_DEV(0)

#define	CONFIG_ZTIMER_USEC_MIN (2)

Define the interface to the AT86RF231 radio
{spi bus, spi speed, cs pin, int pin, reset pin, sleep pin}
#define	AT86RF2XX_PARAM_CS GPIO_PIN(PORT_A, 4)

#define	AT86RF2XX_PARAM_INT GPIO_PIN(PORT_C, 4)

#define	AT86RF2XX_PARAM_SLEEP GPIO_PIN(PORT_A, 2)

#define	AT86RF2XX_PARAM_RESET GPIO_PIN(PORT_C, 1)

LED pin definitions and handlers
#define	LED0_PIN_NUM 2

#define	LED0_PORT GPIO_PORT_D
	GPIO port of LED 0.

#define	LED0_PORT_NUM PORT_D

#define	LED1_PIN_NUM 5

#define	LED1_PORT GPIO_PORT_B
	GPIO port of LED 1.

#define	LED1_PORT_NUM PORT_B

#define	LED2_PIN_NUM 10

#define	LED2_PORT GPIO_PORT_C
	GPIO port of LED 2.

#define	LED2_PORT_NUM PORT_C

Files