gpio_params.h

Go to the documentation of this file.

/*
 * Copyright (C) 2017 SKF AB
 *
 * This file is subject to the terms and conditions of the GNU Lesser
 * General Public License v2.1. See the file LICENSE in the top level
 * directory for more details.
 */
 
#pragma once
 
#include "board.h"
#include "saul/periph.h"
 
#ifdef __cplusplus
extern "C" {
#endif
 
static const  saul_gpio_params_t saul_gpio_params[] =
{
    /* These LEDs are marked on the board silkscreen with "LED3" for the red LED,
     * and "LED4" for the RGB LED, hence the names for the SAUL actuators don't
     * match the LEDx_PIN macros in board.h */
    /* LED1 and LED2 on the board are wired to the target CPU reset pin, and the
     * power supply line and are not software controllable */
    {
        .name = "LED3",
        .pin = LED0_PIN,
        .mode = GPIO_OUT,
        .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
    },
    {
        .name = "LED4_R",
        .pin = LED1_PIN,
        .mode = GPIO_OUT,
        .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
    },
    {
        .name = "LED4_G",
        .pin = LED2_PIN,
        .mode = GPIO_OUT,
        .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
    },
    {
        .name = "LED4_B",
        .pin = LED3_PIN,
        .mode = GPIO_OUT,
        .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
    },
    {
        .name = "SW3",
        .pin = BTN0_PIN,
        .mode = BTN0_MODE,
        .flags = (SAUL_GPIO_INVERTED),
    },
    {
        .name = "SW4",
        .pin = BTN1_PIN,
        .mode = BTN1_MODE,
        .flags = (SAUL_GPIO_INVERTED),
    },
};
 
#ifdef __cplusplus
}
#endif