gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2025 David Picard
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
16 #include "board.h"
17 #include "saul/periph.h"
18 
19 #ifdef __cplusplus
20 extern "C" {
21 #endif
22 
26 static const saul_gpio_params_t saul_gpio_params[] =
27 {
28  {
29 #ifdef MODULE_PERIPH_INIT_BUTTONS
30  .name = "BOOT",
31  .pin = BTN0_PIN,
32  .mode = BTN0_MODE,
33  .flags = SAUL_GPIO_INVERTED
34 #endif
35  },
36 };
37 
38 #ifdef __cplusplus
39 }
40 #endif
41 
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
Button configuration.
Definition: gpio_params.h:26
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.