gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2018 HAW Hamburg
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "board.h"
19 #include "saul/periph.h"
20 
21 #ifdef __cplusplus
22 extern "C" {
23 #endif
24 
28 static const saul_gpio_params_t saul_gpio_params[] =
29 {
30  {
31  .name = "LED Builtin",
32  .pin = LED0_PIN,
33  .mode = GPIO_OUT
34  },
35  {
36  .name = "LED Red",
37  .pin = LED1_PIN,
38  .mode = GPIO_OUT,
39  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR)
40  },
41  {
42  .name = "LED Green",
43  .pin = LED2_PIN,
44  .mode = GPIO_OUT,
45  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR)
46  },
47  {
48  .name = "LED Blue",
49  .pin = LED3_PIN,
50  .mode = GPIO_OUT,
51  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR)
52  }
53 };
54 
55 #ifdef __cplusplus
56 }
57 #endif
58 
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition: board.h:32
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:161
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:43
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
GPIO pin configuration.
Definition: gpio_params.h:28
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.