gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2025 TU Dresden
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "board.h"
19 #include "saul/periph.h"
20 
21 #ifdef __cplusplus
22 extern "C" {
23 #endif
24 
28 static const saul_gpio_params_t saul_gpio_params[] =
29 {
30  {
31  .name = "red LED top right",
32  .pin = LED0_PIN,
33  .mode = GPIO_OUT
34  },
35  {
36  .name = "green LED top left",
37  .pin = LED1_PIN,
38  .mode = GPIO_OUT
39  },
40  {
41  .name = "blue LED bottom left",
42  .pin = LED2_PIN,
43  .mode = GPIO_OUT
44  },
45  {
46  .name = "red LED top left",
47  .pin = LED3_PIN,
48  .mode = GPIO_OUT
49  },
50  {
51  .name = "green LED top left",
52  .pin = LED4_PIN,
53  .mode = GPIO_OUT
54  },
55 };
58 #ifdef __cplusplus
59 }
60 #endif
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition: board.h:32
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:161
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
GPIO pin configuration.
Definition: gpio_params.h:28
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.