gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2020 Inria
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "board.h"
19 #include "saul/periph.h"
20 
21 #ifdef __cplusplus
22 extern "C" {
23 #endif
24 
28 static const saul_gpio_params_t saul_gpio_params[] =
29 {
30  {
31  .name = "LED0 (Orange)",
32  .pin = LED0_PIN,
33  .mode = GPIO_OUT,
34  },
35  {
36  .name = "LED1 (RED)",
37  .pin = LED1_PIN,
38  .mode = GPIO_OUT,
39  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
40  },
41  {
42  .name = "LED2 (GREEN)",
43  .pin = LED2_PIN,
44  .mode = GPIO_OUT,
45  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
46  },
47  {
48  .name = "LED3 (BLUE)",
49  .pin = LED3_PIN,
50  .mode = GPIO_OUT,
51  .flags = (SAUL_GPIO_INVERTED | SAUL_GPIO_INIT_CLEAR),
52  },
53  {
54  .name = "LED4 (PWR)",
55  .pin = LED4_PIN,
56  .mode = GPIO_OUT,
57  },
58 };
59 
60 #ifdef __cplusplus
61 }
62 #endif
63 
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition: board.h:32
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
LED configuration.
Definition: gpio_params.h:28
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:161
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
SAUL_GPIO_INIT_CLEAR
@ SAUL_GPIO_INIT_CLEAR
set pin inactive after init
Definition: periph.h:43
SAUL_GPIO_INVERTED
@ SAUL_GPIO_INVERTED
pin is used as inverted
Definition: periph.h:42
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.