board.h File Reference
Boards » IoT-LAB M3 open node

Board specific definitions for the iotlab-m3 board. More...

Detailed Description

Board specific definitions for the iotlab-m3 board.

Author
Alaeddine Weslati alaed.nosp@m.dine.nosp@m..wesl.nosp@m.ati@.nosp@m.inria.nosp@m..fr
Thomas Eichinger thoma.nosp@m.s.ei.nosp@m.ching.nosp@m.er@f.nosp@m.u-ber.nosp@m.lin..nosp@m.de
Oliver Hahm olive.nosp@m.r.ha.nosp@m.hm@in.nosp@m.ria..nosp@m.fr
Hauke Petersen hauke.nosp@m..pet.nosp@m.ersen.nosp@m.@fu-.nosp@m.berli.nosp@m.n.de

Definition in file board.h.

#include <stdint.h>
#include "cpu.h"
#include "periph_conf.h"
#include "board_common.h"
+ Include dependency graph for board.h:

Go to the source code of this file.

Define the interface for the connected flash memory

#define EXTFLASH_SPI   SPI_DEV(1)
 
#define EXTFLASH_CS   GPIO_PIN(PORT_A, 11)
 
#define EXTFLASH_WRITE   GPIO_PIN(PORT_C, 6)
 
#define EXTFLASH_HOLD   GPIO_PIN(PORT_C, 9)
 

Define the interface to the LPS331AP pressure sensor

#define LPSXXX_PARAM_ADDR   (0x5C)
 

Define the interface for the L3G4200D gyroscope

#define L3G4200D_PARAM_INT2   GPIO_PIN(PORT_C, 0)
 
#define L3G4200D_PARAM_INT1   GPIO_PIN(PORT_C, 5)
 

Define the interface to the LSM303DLHC accelerometer and magnetometer

#define LSM303DLHC_PARAM_ACC_PIN   GPIO_PIN(PORT_B, 12)
 
#define LSM303DLHC_PARAM_MAG_PIN   GPIO_PIN(PORT_B, 2)
 

MTD configuration

#define MTD_0   mtd_dev_get(0)
 SPI NOR Flash device.