gpio_params.h
Go to the documentation of this file.
1 /*
2  * SPDX-FileCopyrightText: 2019 Inria
3  * SPDX-License-Identifier: LGPL-2.1-only
4  */
5 
6 #pragma once
7 
18 #include "board.h"
19 #include "saul/periph.h"
20 
21 #ifdef __cplusplus
22 extern "C" {
23 #endif
24 
28 static const saul_gpio_params_t saul_gpio_params[] =
29 {
30 #ifdef MODULE_PERIPH_INIT_LED0
31  {
32  .name = "LD1 (blue)",
33  .pin = LED0_PIN,
34  .mode = GPIO_OUT
35  },
36 #endif
37  {
38  .name = "LD5 (red)",
39  .pin = LED1_PIN,
40  .mode = GPIO_OUT
41  },
42  {
43  .name = "LD6 (green)",
44  .pin = LED2_PIN,
45  .mode = GPIO_OUT
46  },
47  {
48  .name = "B1",
49  .pin = BTN0_PIN,
50  .mode = BTN0_MODE
51  },
52 };
53 
54 #ifdef __cplusplus
55 }
56 #endif
57 
LED2_PIN
#define LED2_PIN
RX LED yellow.
Definition: board.h:32
GPIO_OUT
@ GPIO_OUT
select GPIO MASK as output
Definition: periph_cpu.h:161
periph.h
Parameter definitions for mapping peripherals directly to SAUL.
saul_gpio_params
static const saul_gpio_params_t saul_gpio_params[]
GPIO pin configuration.
Definition: gpio_params.h:28
saul_gpio_params_t
Direct mapped GPIO configuration values.
Definition: periph.h:50
saul_gpio_params_t::name
const char * name
name of the device connected to this pin
Definition: periph.h:51
board.h
Board specific definitions for the Zigduino board.